2x same interface displayed

Think you've found a bug? Post a description here.

Moderator: Serin

Post Reply
Tornado
Senior User
Posts: 234
Joined: Tue Jun 08, 2004 9:39 am
Location: Australia

2x same interface displayed

Post by Tornado » Thu Feb 10, 2005 8:33 am

Hello,

Not sure what happened, but from what I recall, these are the steps I took.

1. Started the program (waited a while)
2. Went to the file menu --> start server

Then I had x.x.x.x appear twice in the interface box.

Thanks.
Last edited by Tornado on Tue Jun 07, 2005 9:16 pm, edited 1 time in total.

User avatar
Serin
Site Administrator
Posts: 1785
Joined: Sat Jan 01, 2005 6:57 pm
Location: United States
Contact:

Post by Serin » Thu Feb 10, 2005 8:35 pm

Cerberus is designed to automatically detect new interfaces every few minutes. However, it should not detect the same interface twice. Are you sure it is detecting the exact same IP?

Thanks,

Tornado
Senior User
Posts: 234
Joined: Tue Jun 08, 2004 9:39 am
Location: Australia

Post by Tornado » Fri Feb 11, 2005 10:29 pm

I had a close look at it a few times in the short time frame, because I didn't believe I was seeing the same IP address, but from what I can remember, I do believe it was the same IP address shown.

Maybe run some tests checking all possible pathways and also logic in the code ... otherwise leave it and I'll re-report it if it happens again. I'm sure there are more urgent matter to attend to in the pipeline

I should of screen dumped it immediately when it happened, but I didn't :-(

Cheers!

Post Reply